Replacement Assembly for Kwikee Steps With Discontinued 151332 Gear Box on 1999 Fleetwood Bounder

Question

Question:

I have a 1999 bounder with kwikee step. gear box has a number 151332. which assembly do I need. would like to replace the complete assy.

asked by: Duane B

0

Expert Reply:

From what I have found, the 151332 gear box was on both the 28 series and 32 series steps. If you have a single step on your 1999 Fleetwood Bounder then you can use the Kwikee Electric RV Step Complete Assembly - Single - 28 Series - 23-5/8" Wide # LC3747453 as a replacement.

If you have the two step 32 series the correct assembly would be the Kwikee Electric RV Step Complete Assembly - Double - 32 Series - 24" Wide # LC372261.

expert reply by: Robin H

0

Answer 1

Yes, you can bypass the door switch on your Lippert steps. You can do this by connecting the two wires together. If your steps operate then you know the switch is bad and can replace it with the Replacement Door Switch #LC301694 if you have the…

view full answer...

Answer 2

In order to test the motor on what I assume are set of Lippert Kwikee Electric Steps, you will first want to sever the yellow and red wires on the motor. Once you do this you will then need to obtain access to a 12 volt power source you know…

view full answer...

Answer 3

Based on the age of your Holiday Rambler the correct motor replacement is the Lippert Components Kwikee Step Motor Replacement Kit For Pre-IMGL #LC379608. However, I strongly recommend instead going with the Kwikee Step Motor Conversion/Upgrade Kit…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 5

It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…

view full answer...

Answer 6

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Replacement Assembly for Kwikee Steps With Discontinued 151332 Gear Box on 1999 Fleetwood Bounder

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching