How to Test to Determine Correct Stoplight Switch Circuit for Red Wire of Brake Controller Install
Question:
Need to know what color wires on the truck brake light switch goes to the color wires on a POD brake controller?
asked by: Deidra M
0
Expert Reply:
Since we don't know what the wire color functions are on the brake switch of your truck the best solution we have would be to use a circuit tester like part # PTW2993 to test all of the wires for voltage only when the brakes are applied to see which is correct wire to use for red wire of the brake controller.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Can the Curt Custom Tail Light Wiring Kit Be Used With LED Lights