Can Just the Mast Be Replaced On Rooftop Antenna for RV Stereo

Question

Question:

Do you sell this antenna,Mast only or any others like it?

asked by: Larry P

0

Expert Reply:

We do offer various different antennas for RV stereos like the Jensen Antenna part # 44US01R or part # JAN139. The difference mostly comes down to mast length, mount type, and cable length. The actual plug which goes into the stereo is universal so you don't have to worry about brand. That said, the actual mast is specific to the base which means you can't usually just replace this part so you'll need a new unit if yours is gone or damaged.

I have attached our full list of antenna options below.

expert reply by: Conner L

0

Answer 1

Yes, I contacted Jensen and they confirmed the connector on the Jensen RB Antenna #1181039 is a Motorola-type connector. Check out the video linked below for more details on this product.

view full answer...

Answer 2

The mast of the Jensen Antenna #44US01R that you referenced can be easily removed by taking out the screw that attaches it to the base (see attached). The mast is actually rubber so I doubt it will do any damage to your cover if you fold it down,…

view full answer...

Answer 3

Here is a list of the Jensen radio antennas we currently carry. You can compare these with the one on the roof of your 2016 Thor Challenger 37LX to determine if we have an exact replacement or if you will need to remove the antenna from your roof to…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Yes, the Replacement 17-rpm Lift Motor for Fan-Tastic Vent B Series #FVK6010-80 can be used in place of the 7-rpm Lift Motor FVK6050-80, as long as you swap the wires like you mentioned.

view full answer...

Answer 7

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Answer 8

Hey Beatrice, To find the right fit for your trailer's suspension you'll need to take a quick measurement of your current shackle straps. You'll need to measure from the center of one bolt hole to the center of the other bolt hole. The…

view full answer...

Answer 9

Hey Dave, the MORryde upgraded shackle kit part #MR76ZR that you referenced is compatible with your 2020 Grand Design 2670MK and the Lippert Road Armor equalizers.

view full answer...

Answer 10

I am sorry but we do not have an AC cover with those dimensions. The closest option we have is the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners item #AT3308046006 which measures 40-1/2" long x 29" wide x…

view full answer...

Can Just the Mast Be Replaced On Rooftop Antenna for RV Stereo

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching