What Material is Quick Release Connector of Comfort Ride Transom Saver Made of

Question

Question:

Is the quick-release adapter onto your trailer made of stainless steel or aluminum?

asked by: Jim

0

Expert Reply:

The quick release portion of the Comfort Ride Transom Saver # 315-FXH that attaches to your trailer is aluminum.

expert reply by: Jameson C

0

Answer 1

I recommend the Tourney Pro Transom Saver #315-FXJ for your 5'x8' plastic boat. The transom saver is definitely recommended with the lightweight plastic boat you have. With this transom saver you can mount it to the trailer by sliding it onto…

view full answer...

Answer 2

Once the programming is complete you would be able to remove the SuperChips part #SU1845. It only needs to be connected when programming. After that you could put it in the glove box.

view full answer...

Answer 3

Vehicle owners' factory warranties are protected by Federal Magnusson-Moss Warranty Act. The Act states that if something breaks on your vehicle and you take it in for warranty repair, the dealer must honor your warranty unless whatever…

view full answer...

Answer 4

You are correct. The Superchips Flashpaq F5 Performance Tuner, part #SU1845 has many of the same features as the more expensive models and will work great for your 2004 F-250 Diesel. This tuner just plugs into the OBD-ll port on your truck and is a…

view full answer...

Answer 5

I went out in our warehouse and measured the Tourney Transom Saver #315-FXK. The end that you would use to connect to the trailer has a 3/4" by 3/4" inner diameter. The bolt hole is centered 1/2" in from the end of the tubing. Based on…

view full answer...

Answer 6

Thanks for the photos! From what I'm seeing it looks like you're needing the Replacement Adapter Port for Kodiak Disc Brake Calipers and Solenoid Valves #K22590A. This has the same basic design shown in your pictures and it has 1/8" NPT…

view full answer...

Answer 7

The Stainless Steel Hex Lag Screw #FA74521 contains one 3/8" diameter, 1-1/4" long lag screw.

view full answer...

Answer 8

What I recommend is to use 2 sets of the roller bunks #DL21740. Two bunks can cover the length of one bunk but you will need to trim one to fit. One set would be needed per bunk and then trimmed to fit. One roller bunk alone is 4 feet long. Normally…

view full answer...

What Material is Quick Release Connector of Comfort Ride Transom Saver Made of

Product Page this Question was Asked From

Continue Researching