Mounting Width of Flexco Manual Pull-Out Quad Steps for RVs
Question:
I’ve seen multiple mount dimensions. Which one is correct for the out side measurement of the mounting box? Thank you.
asked by: Josh B
0
Expert Reply:
The outside width of the mounting flange on the Flexco Manual Pull-Out Steps for RVs part # SMFP-4400 is 28-1/8" which you can see in the photo attached below.
expert reply by:
Conner L
0
Mounting Width of Flexco Manual Pull-Out Quad Steps for RVs
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Quad - 8" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 28-1/8 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Availability of Rebuild Kit for Older Blue Ox Aventa Tow Bar BX7330
- Q&A: Can Base Plate Kit And Grille Guard Both Be Installed On 2021 Jeep Wrangler
- Q&A: Dimensions of the Flexco Steps Part # SMFP-4400
- Q&A: Replacement Drain Plug For An Atwood G6A-7 Water Heater
- Q&A: Replacement for High Pointe 50f11 Range Hood
- Q&A: RV Step Recommendation that Can Fit 27 inch Wide Mounting Brackets
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Q&A: Recommended 4-Step RV Steps To Replace 3-Step On 289RK Denali Travel Trailer
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Measure for Motorhome Steps
- Article: The Best Towing Mirrors
- Article: The 5 Best Trailer Drop Hitches You Can Buy