Can Gen-Y Glyder Shock Absorbing Ball Mount be Used with NuCamp Tab 400

Question

Question:

Would my NuCamp Tab 400 tear camper be too light for your Gen Y 2ball-6 ,shock absorbing ball mounts? It weighs under 3,000lbs.

asked by: Gail G

1

Helpful Expert Reply:

Your tongue weight would be a little light for the Gen-Y Glyder Shock Absorbing Ball Mount for 2" Hitches # 325-GH-12005 but it is still going to make a large enough difference for ride quality.

expert reply by: Jameson C

1

Answer 1

There is a correction for the Gen-Y Glyder Shock Absorbing Ball Mount #325-GH-12005. It is only capable of being mounted in the drop position. To get the rise you are looking for in a shock absorbing style hitch I recommend the Convert-A-Ball Ball…

view full answer...

Answer 2

I took a look at the owner's manual for your 2022 Volkswagen Atlas and it states, "Never install weight distributing or load equalizing ball mounts. The vehicle was not designed for these types of trailer hitches. The trailer hitch…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Can Gen-Y Glyder Shock Absorbing Ball Mount be Used with NuCamp Tab 400

Product Page this Question was Asked From

Continue Researching