Installation and Placement of the Repeater for the Tuson Towable Tire Pressure Monitoring System

Question

Question:

Does the repeater need to be mounted outside of the trailer or can it be mounted in the underpass?

asked by: Blue_Road_Writers

0

Expert Reply:

The repeater of the Tuson Towable Tire Pressure Monitoring System, # 335TPMS4WIVS can be mounted inside the cargo area of the RV. However, ideally, to get best RF transmission between repeater and tire pressure sensors, it should be in an open space and no/limited barriers between tire pressure sensors.

For travel trailers with a bumper pull A-frame hitch, it is best place the repeater onto the A-frame area of the trailer and then use the self-tapping screws to fasten it to the A-frame. While for 5th Wheels and gooseneck trailers select a location for the repeater near the house battery.

expert reply by: Michael R

0

Answer 1

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds. You will get a visual and audible alert when the monitor receives the signal from your tire sensor is either below your pressure or the temperature exceeds the maximum setting.

view full answer...

Answer 2

Tireminder recommends installing the signal booster like what comes with the part #TM89FR close to the middle of the towing rig and as far to the outside as possible. So for a fifth wheel trailer setup you'd want to install it as close to the…

view full answer...

Answer 3

Hello, Phil. Yes, the bolts that go into the adapters at the end of the arms should be torqued. It looks like those are 5/16" grade 5 bolts so they should be torqued to 18 ft lbs. I have included the torque chart below for your reference.

view full answer...

Answer 4

Even when stored in the somewhat controlled environment of a garage, tires are still subject to dry rot and flat spotting. Even if the tire tread has plenty of depth left and you can't see any cracking with the naked eye, the generally accepted…

view full answer...

Answer 5

Yes, you can swap out your cap sensors for internal sensors and they will work with your current TST-507-RV-4 system. We offer the internal sensors individually with part #TST-507-INT-S1. Definitely a good idea if you don't want to have to worry…

view full answer...

Answer 6

I recommend checking out the TST TPMS for RVs - Color Display - Signal Booster #TST-507-FT-4-C. This is my personal choice if given one because it's simple to use, and you don't have to remove the sensors every time you air up. It may not…

view full answer...

Answer 7

I sent your question to Tuson about the Tuson RV and Trailer TPMS #335TPMS4WIVS and they sent me the following with the attached picture: Based on our test results in an open space environment (without considering the shielding effect of vehicle…

view full answer...

Answer 8

For your 2018 Grand Design Solitude the factory temperature sensor for high temp is 158 degrees. This is based on the Michelin Standard for tire temperature. It is the same for all size tires. Usually a tire will not expand enough to blow until it…

view full answer...

Answer 9

The Power Inverter 1000 Watts with Three AC Receptacles #WC3720 that you referenced has three standard outlets on the back of it for powering accessories like you mentioned. There's no additional wiring needed to plug in a microwave or coffee…

view full answer...

Answer 10

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Installation and Placement of the Repeater for the Tuson Towable Tire Pressure Monitoring System

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching