Axle Diameter for 60 Inch Long 2,200 lb etrailer Axle
Question:
Hi. What is the O.D. of the axle tube?
asked by: Bill D
1
Helpful Expert Reply:
The Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,200 lbs # e22GR has a 1-3/4" diameter for the outer tube. You can see us go over this spec in the attached review video.
expert reply by:
Jon G
1
Product Page this Question was Asked From
Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,200 lbs
- Trailer Axles
- Leaf Spring Suspension
- Easy Lube Spindles
- Idler Hubs
- 2200 lbs
- 5 on 4-1/2 Inch
- 48 Inch Long
- 60 Inch Long
- No Drop or Lift
- etrailer
more information >
Continue Researching
- Q&A: Wiring configuration for Atwood GC6AA-10E Water Heater
- Q&A: Troubleshooting Fan-Tastic Roof Vent Remote that Won't Program
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: USA Made Bearing Kit For An AL-KO 4,400 lb Axle
- Q&A: What is the Offset of a Trailer Wheel
- Q&A: Replacement Leaf Springs for Harbor Freight Folding Trailer
- Q&A: What Gauge Wire Is Needed To Run Charge Line for Battery From Truck to Trailer
- Article: Trailer Tire Sizing
- Q&A: Grease Seal Recommendation to Replace TCM 21334
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure a Trailer Axle
- Article: Most Popular Wheel Bearings
- Article: How to Raise Your Travel Trailer Height
- Article: How to Replace Trailer Leaf Springs in 5 Steps