Dimensions of the Jack-It 2 Bike Rack
Question:
What is the measurement from the base of the unit to the upper tire rest, with it located in the highest hole? Also, can the Y portion be located into the base without using the angled piece? Or do you make an adapter to allow it to go straight up instead of to the rear? Thanks!
asked by: Tom
Expert Reply:
The highest hole for the upper tire rest is 60-3/8" from the bottom of the base on the Jack-It 2 Bike Rack for A-Frame Trailers - 22-1/2" Jack Clearance item # LC429756. The angled piece has to be used to connect the y portion of the rack to the tower portion of the base. The orientation of the pin holes will prevent you from using the two pieces without the angled connector. There are no adapters to get around this. I have linked a couple of diagrams that will show the dimensions of the Jack-It 2 Bike Rack.
(click to enlarge)
(click to enlarge)
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Carry Bikes While Towing a Travel Trailer
- Q&A: Bike Rack Recommendation for NuCamp 320 Camper
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Trailer Wiring Diagrams
- Q&A: Recommended AC With Heat Strip for Enclosed Trailer
- Q&A: Bike Rack Solution for Carrying Bikes between Tow Vehicle and Camper
- Q&A: Straight Stinger for Jack-It 2 Bike Rack for A-Frame Trailers
- Q&A: Orientation of Jack-It 2 Bike Rack for A-Frame Trailers Installed on Camper Trailer
- Q&A: Fitment of the Hitch-It 2 # LC731138 to a 10" Straight Trailer Tongue
- Q&A: Converting a Hymer Touring GT Camper from Surge to Electronically Controlled Brakes
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Best Bike Racks for Electric Bikes