Parts Needed to Flip 2,000 Pound Axle With Slipper Springs
Question:
I have a Carry-On 5x8 trailer with a 2000 lb axle. Sticker on the axle says Axis Products Inc., part number 2K7058. Its mounted on slipper springs. Im looking to flip the axle for ground clearance. Im looking to use the TRSS175 spring seats and APUBR-10 U-bolt kit you mention in other questions. Can this conversion be done on an axle mounted on slipper springs? In the instructions for other over/under axle conversion kits, it says they may only be used on double-eye springs. Why is that? Thanks.
asked by: Mike T
Expert Reply:
Technically the over-under conversion kit can be used with slipper springs if the spring seats are fully welded to the trailer axle and you would have to use a u-bolt plate that fits the springs. Since you have a 2,000 lb axle this doesn't matter since there is not a kit that fits a 1-3/4" diameter axle like the one you have.
You can do the same thing with the U-Bolt Kit for Mounting 2,000-lb, Round Trailer Axles - 4-1/4" Long U-Bolts # APUBR-10 assuming you have 1-3/4" slipper springs. You would also need to have the Spring Seat for Typical 2,000-lb, Round Trailer Axles with 1-3/4" Diameter - Qty 1 # TRSS175 welded on.
Products Referenced in This Question
Spring Seat for Typical 2,000-lb, Round Trailer Axles with 1-3/4" Diameter - Qty 1
- Trailer Suspension Parts
- Spring Seats
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Round Axle - 1-3/4 Inch
- TruRyde
more information >
Product Page this Question was Asked From
U-Bolt Kit for Mounting 2,000-lb, Round Trailer Axles - 4-1/4" Long U-Bolts
- Trailer Suspension Parts
- U-Bolt Kits
- Camper
- Car Hauler
- Utility Trailer
- 2000 lbs
- Round Axle - 1-3/4 Inch
- 3/8 Inch Diameter
- 4-1/4 Inch Long
- Dexter
more information >
Continue Researching
- Q&A: Can etrailer 2,000 lb Axle be Flipped
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Axle And Leaf Springs For A 4' x 6' Single Axle Trailer
- Article: Trailer Tire Sizing
- Q&A: Is There An Axle Flip Kit for a 2,000 Lb 1-3/4 Inch Diameter Axle
- Q&A: Could Shackle Bolt # 166081 be Used with CE Smith Suspension Hanger # CE14016G
- Article: Where to Position the Trailer Axle?
- Q&A: How To Measure For Hub-Face And Spring Center Measurements On An Axle
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Wiring Diagrams
- Q&A: Torque Spec for U-Bolts on 2K Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 60" Long
- Article: How to Raise Your Travel Trailer Height
- Q&A: Can an Axle Over Under Kit be Made for 1-3/4 inch Trailer Axle
- Article: 7 Common Questions Everyone Has About Trailer Tires