Nerf Bar Steps That Fit 2022 Ram 2500 Mega Cab With 6-1/2' Bed

Question

Question:

Will these fit a 2022 ram 2500 mega cab 6.5 ft bed WE87FR

asked by: BJ M

0

Expert Reply:

We have running boards that fit your 2022 Ram 2500 Mega Cab with a 6-1/2' bed, but the Westin nerf bars do not; they only fit Crew Cab short beds. Instead, what you will need are nerf bars from DeeZee:

- DeeZee Oval Tube Steps with Custom Installation Kit # DZ16111-16336

The DeeZee # DZ16111-16336 fit your truck and give you a large, 6" wide step that is made of 16-gauge steel. So you're getting not only a large surface that makes it easy to hop in your truck, but also an extremely robust one.

expert reply by: Kyle S

0

Answer 1

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 2

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 3

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 4

Air bags like the Air Lift LoadLifter 5000 #AL88289 should be filled to a minimum of 5 PSI at all times. Filling them beyond that is done after the truck is loaded. The steps will go as follows: 1. Inflate air bags to at least 5 PSI 2. Load…

view full answer...

Answer 5

There should be a sticker or plate on the pin box itself that lists the manufacturer and model of the pin box. If it is not present then there are some measurements you can take to determine the model of the pin box. I have included a link that…

view full answer...

Answer 6

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 7

The Air Lift LoadLifter 7500 XL Air Helper Springs part #AL57589 are designed to be used in conjunction with a coil spring rear suspension. The air bags do not replace these but rather work alongside them. The air bags also do not work with models…

view full answer...

Answer 8

The factory prep package on a 2018 Ram 3500 is pretty apparent so odds are you don't have this if you are unsure. If the indentations for the four outer pucks and center gooseneck hitch ball are present but there are no actual holes in the truck…

view full answer...

Answer 9

Yes! To add both anti-rattle and a lock to the Blue Ox Adjustable Ball Mount with Clamshell for 2-1/2" Hitch #BLU79XR you need the XL Anti-Rattle Trailer Hitch Receiver Lock for 2-1/2" Hitches #SHP2040-XL. This has a block insert with a…

view full answer...

Answer 10

Since the trailer was off of the ground it would not take much voltage to stop the wheels from spinning so they may be getting power but they may not be getting enough power due to a short or wiring issue. But 9 times out of 10 weak trailer brakes…

view full answer...

Answer 11

Congratulations on your new truck bed camper! I'm sure you will enjoy it for many years. Sway is a common issue with truck bed campers which can be reduced, but not eliminated. The campers are not particularly aerodynamic and the sway will…

view full answer...

Nerf Bar Steps That Fit 2022 Ram 2500 Mega Cab With 6-1/2' Bed

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching