Troubleshooting Atwood Switch Light Not Staying Lit While Hot Water Heater Burner Remains Lit

Question

Question:

Light wont stay on wall but burners lit

asked by: Mandersontpa

0

Expert Reply:

As long as the burner is lit on the hot water heater you shouldn't have a problem. If the light is not functioning on the switch then you can double check the 12V power on the back. Assuming you're getting power, it is a problem with the switch itself. For a replacement, you can use the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters - White # AT91230.

expert reply by: Robin H

0

Answer 1

I have attached the wiring diagram for the Replacement Double-Panel On/Off Switch for Atwood Gas and Electric Combination Water Heaters part #AT91230. The installation will be very simply with only 5 connections needed. There will be three terminals…

view full answer...

Answer 2

I assume you were referencing the Replacement Double-Panel On/Off Switch for Atwood Gas and Electric Combination Water Heaters #AT91230 as there is not a part 92230. I have added a diagram of the instructions for you, and you'll hook up three of…

view full answer...

Answer 3

We no longer have a direct replacement available to your Atwood GC6AA-10E water heater. We do have the Atwood RV Gas and Electric Water Heater with 10 Gal Tank, #AT94022. This RV water heater uses an automatic direct-spark gas pilot and an internal…

view full answer...

Answer 4

I am not sure what the different wires on your Jayco Jay Flight 2077BHS are connected to but from my understanding the new water heater should be configured as follows: Blue - Lock Out Lamp Green - Ground Orange - Gas Control White - Electric Control…

view full answer...

Answer 5

There are many variables when installing the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters part #AT91230 therefore it is best to match the wire to the terminals using its function, not the color. The reason for this…

view full answer...

Answer 6

The manual for the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters - White #AT91230 lists the wire as orange but the manual for Atwood water heaters like AT94022 list the wire as red. It's referring to the wires…

view full answer...

Answer 7

If you are wanting an exact replacement, we do not carry the Dometic GC6AA-10E. We do carry the Atwood RV water heater we currently have is the #AT94022. This is a gas/electric with automatic pilot that operates at 120 Volt on electric. It is a…

view full answer...

Answer 8

Since the middle light flickered when you were installing the Replacement Double-Panel On/Off Switch #AT91230 it sounds like either the power or the ground pin has an issue. Try checking the wire for the power (should be blue according to the…

view full answer...

Answer 9

We carry the following replacement parts for your Atwood RV Water Heater AT94022: Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters #AT91230. Replacement Door for Atwood RV Water Heaters #AT91385. If you are needing some…

view full answer...

Answer 10

For a replacement for your water heater we currently have a 6 gallon Dometic RV Water Heaters - #DMC74FR. Then you could add the Double-Panel On/Off Switch, part #AT91230, that would allow you to power the electric and gas components on and off…

view full answer...

Answer 11

To install the Dometic water heater part #DMC74FR in place of your current Dometic setup what you need is the adapter part #DMC24FR and you'd be set.

view full answer...

Answer 12

I added a photo which shows the location of the heating element of the Atwood Water Heater GC6AA-10E for you. It is item number 17 in the diagram. Atwood does recommend having a professional do the job if you are replacing it due to its location.

view full answer...

Troubleshooting Atwood Switch Light Not Staying Lit While Hot Water Heater Burner Remains Lit

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching