2-1/2" Round Trailer Lights that are Recessed Mounted and Rubber Grommet for 2-3/4" Hole

Question

Question:

I have a PJ trailer that needs new clearance lights and gromets. The holes in the trailer for the lights measure 2 3/4. Would part # A57GB Gromet and MCL59AB and MCL59RB lights fit?

asked by: Mike B

1

Helpful Expert Reply:

Yes, the Rubber Grommet for 2-1/2" Round Trailer Lights - Recessed Mount, # A57GB requires a 2-3/4" diameter cutout for installation and allows you to use a recessed mounted 2-1/2" diameter sealed light such as the LED Trailer Clearance or Side Marker Light, # MCL59AB or # MCL59RB.

expert reply by: Michael R

1

Answer 1

It's totally normal for a bit of movement between any fifth wheel hitch and the base rails. The feet on the hitch are typically a bit smaller than the slots they slide into for mounting otherwise you'd have a hard time getting your…

view full answer...

Answer 2

For a pair of stabilizer jacks that would have more than enough capacity that would work well on your R-Pod I would recommend the Stromberg Carlson Trailer Scissor Jacks part #JSC-24. These have a 5k capacity per jack and would do a great job as…

view full answer...

Answer 3

There is not a fuse we carry for the 8000 Series of Fan-Tastic vent. It does use a 4 amp slow blow fuse so to make fuse access simpler you can use In-Line Fuse Holder #C58470-1 and if you need to replace the bow-tie bracket, motor, and blade the…

view full answer...

Answer 4

All of the 2015 Honda Pilots would have a hitch installed on them from Honda. So that is one less piece of the puzzle that you would need. Since you wanted to do some towing you might be interested in etrailer ball mount kit #989900. It comes with 2…

view full answer...

Answer 5

It looks like all 2015 Honda Pilots come equipped with a hitch already (save for a select few). It's for that reason that none of our manufacturers made hitches for it, and why the 2016 hitches will not fit. In the middle of your back bumper, you…

view full answer...

Answer 6

The Curt Adjustable Width Trailer Hitch Receiver for RVs #13703 uses frame brackets for installation, and those need to be positioned on the inside of an I-beam frame, as per the instructions (a copy of which I have linked for you). That is what will…

view full answer...

Answer 7

There are 2 different capacities independent of each other though related. Tongue weight is the downward force or weight on the trailer hitch. So it is pushing down at the back of the vehicle. The gross trailer weight is the weight of whatever it is…

view full answer...

Answer 8

I really wish we had replacement parts still for the Atwood couplers but since they've been out of business for so long we don't have any way to get the parts you are wanting.

view full answer...

Answer 9

Yes, you can replace your GE air conditoner with an Advent air conditioner like the Advent Air RV Air Conditioner #ACM150. Additionally, you will also need a thermostat. For that, you can use the Air Distribution Box w/ Built-In Thermostat for Advent…

view full answer...

Answer 10

When installing the Tekonsha Prodigy P2 Trailer Brake Controller #90885, we need go back under the dash to find the factory wiring on your truck. Now it's located behind the dash underneath the steering wheel just a little towards the left and a…

view full answer...

2-1/2" Round Trailer Lights that are Recessed Mounted and Rubber Grommet for 2-3/4" Hole

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching