Can Slipper Spring Replace Existing Double Eye Leaf Spring
Question:
I’m refurbishing my boat trailer. I can see that the leaf springs are the open eye type at one end. I was wondering if I can use double eye leaf springs instead of the open eye type if the measurement matches a double eye spring. Is this advisable?
asked by: Richard C
Expert Reply:
You could replace a double-eye leaf spring with a slipper spring like the # e33SR spring you'd looked at, but it's recommended that you remove the existing rear hanger (assuming it's a single axle trailer) with a rear hanger like # 115706S as your existing rear hanger isn't designed for use with slipper springs.
You'll also want to choose a spring with sufficient capacity to handle the weight of the boat and trailer. You can choose a higher rated spring than your existing one, but be aware that doing so won't increase the weight bearing capabilities of your trailer.
Products Referenced in This Question
Rear Hanger for 1-3/4" Slipper Spring
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Slipper Springs - 1-3/4 Inch
- 9/16 Inch Diameter
- Single Axle
- Tandem Axle
- Triple Axle
- Redline
more information >
Product Page this Question was Asked From
etrailer Rust-Resistant 4-Leaf Slipper Spring for 4,300-lb Trailer Axles - 26-1/4" - Dacromet
- Trailer Leaf Springs
- Slipper Springs
- Open Eye
- 4300 lbs
- 1-3/4 Inch Wide
- 4 Leaf
- 26-1/4 Inch Long
- Dacromet
- etrailer
more information >
Continue Researching
- Shop: etrailer Rust-Resistant 4-Leaf Slipper Spring for 4,300-lb Trailer Axles - 26-1/4" - Dacromet
- Shop: CE Smith Bolster and Swivel Bracket Assembly for Roller Bunks - Galvanized Steel - Qty 1
- Video: Review of Trailer Leaf Spring Suspension - Spring Mounting Hardware - 166079
- Q&A: Installation of Slipper Spring with Open Eye End
- Shop: etrailer Rust-Resistant 4-Leaf Double Eye Spring for 4K Trailer Axles - 26" Long - Dacromet
- Search Results: 26 inch leaf spring
- Shop: CE Smith U-Bolt Kit for Mounting 2" Square Trailer Axles - 4-1/2" Long U-Bolts - Zinc
- Q&A: Should a Nylon Bushing Be Used With the Open Eye End Of Slipper Spring # e33SR
- Q&A: Hanger Kits to Use with 1-3/4 inch Wide Slipper Leaf Springs for Trailer
- Q&A: Is There Normally Play In Rear Hanger of Slipper Springs
- Shop: CE Smith Front Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Shop: Nylon Bushing - 9/16" Inner Diameter, 1.024" Outer Diameter - 1-3/4" Long
- Shop: Nylon Bushing - 1/2" Inner Diameter, 7/8" Outer Diameter - 1-3/4" Long
- Q&A: Adding Bunks to 20 Foot Boat Trailer with Deep V Hull
- Q&A: Can 5' Roller Bunks Be Used in Place of 7' Bunk Boards for a 15' Sail Fish Center Console Boat
- Q&A: Roller Bunk Recommendation for a Boat Trailer with Wood Bunks
- Video: Review of Universal Group Trailer Leaf Spring Suspension - Springs - SP-230275
- Video: Redline Trailer Suspension SP01-120 Review
- Video: Review of etrailer 2 Leaf Slipper Spring - e36SR
- Video: etrailer Trailer Idler Hub Assembly Installation
- Search Results: galvanized leaf springs
- Article: Slipper Spring Trailer Suspension System Review
- Video: Review of Redline Replacement Trailer Hub Wheel Stud - 165981
- Video: Wheel Stud Installation on a Boat Trailer
- Search Results: slipper spring
- Search Results: leaf springs
- Search Results: leveling jack
- Search Results: axle
- Search Results: galvanized lug nuts
- Shop: Mud Flaps