Availability of Shade Extension Pieces for Rhino Rack Batwing Awnings

Question

Question:

I see this is what the call the driver side but my camper has the same awning but on the opposite side. Is there a passenger side panel extension available

asked by: Kevin

0

Expert Reply:

I contacted the manufacturer and unfortunately the Front Edge Extension for Rhino-Rack Batwing and Foxwing Awning # RR31124 is only available for the drivers side.

For the Rhino-Rack Batwing Awning - Roof Rack Mount - Bolt On - Passenger's Side # RR33200 there is the Extension Piece for Rhino-Rack Sunseeker, Batwing, and Foxwing Awnings # RR31101.

expert reply by: Scott S

0

Answer 1

I have an answer for you. I reached out to my contact at Yakima and they said that they specially make t-slot hardware for accessories that are designed to fit into LockNLoad Platforms like the #Y05044-39. With that being said, there is no way to…

view full answer...

Answer 2

We do offer replacement nut plates in a hardware bag, part #Y83FR. Yakima doesn't offer the nut plates separately.

view full answer...

Answer 3

The Rhino-Rack Batwing Awning #RR33100 has 4 segments that come off of the vehicle that are 98" long, and has a 118 sq ft coverage.

view full answer...

Answer 4

Thank you for your recent purchase of the Rhino-Rack Batwing Swing-Out Awning #RR33200. My contact at Rhino-Rack was able to advise the brand of zipper on this awning is YKK but the specific size of zipper was not available. It is not offered as a…

view full answer...

Answer 5

When picking between the up #RR32123 or down mount #RR32127 for a Sunseeker awning like the part #RR32132 it comes down to a few factors. The up will put the awning up higher and wouldn't hit the vehicle roof so if had a flush bar roof rack where…

view full answer...

Answer 6

We carry the Replacement Support Arm Assembly #RR33BY which is also referred to as a spar pole. This is only available as an assembly and not separately for only the poles. This fits both the Rhino-Rack Batwing Awning #RR33100 and #RR33200

view full answer...

Answer 7

I went in the warehouse and measured the U-bolt from Rhino-Rack Heavy-Duty Crossbar Fit Kit , part #RUBK-MF. The width from center to center of the U-bolt is 2-5/8 inches. The height of the U-bolt is 3-5/32 inches. The amount of thread on each bolt…

view full answer...

Answer 8

I went out to the warehouse and found that the mounting bracket on the Rhino-Rack RLTP Legs #RRRLTPFC that come with the Rhino-Rack RLTP Legs for Factory Fixed Mounting Points #RRRLTPFC-3 measured about 1-1/4" tall (see attached picture).

view full answer...

Availability of Shade Extension Pieces for Rhino Rack Batwing Awnings

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching