Is Thread Sealant Tape Or Paste Required For Attaching Fittings To An LP Hose
Question:
Just bought propane hose with female flare ends. Do I need to use any tape or paste with these? Thanks
asked by: Roger A
1
Helpful Expert Reply:
Yes, it's always recommended to secure your fitting connections with some thread sealant tape # 37207-30025. You can also use some Gas Pipe Sealant # 37207-30555 in place of the tape if you'd like to go the extra mile for preventing any leaks.
I've attached some videos that will show you use of these products and give you a review of both.
expert reply by:
Kevin C
1
Products Referenced in This Question
Product Page this Question was Asked From
Continue Researching
- Q&A: Replacement Propane Regulator For A Winntec 6020
- Q&A: Solution for Needing Replacement Propane Pigtail Harness
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Q&A: How to Determine if Scissor Jack Will Fit Camper
- Q&A: How Does The Tank Indicator Work On JR Products AutoChange Over Dual Stage Regulator
- Q&A: Should RV Propane Regulator Smell Like Gas
- Q&A: Where is the Automatic Changeover RV LP Gas Regulator Made
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Q&A: Parts Needed To Convert From 30lb Propane Tanks To 100lb Tanks
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Store a Travel Trailer/Camper for the Winter
- Article: Best Camper Jacks
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV