Will Conduit Clamp Set for Rhino-Rack Heavy-Duty Crossbars Work with Aero Crossbars

Question

Question:

Wil these clamps fit my rhino rack vortex bars? they seem to have the same C-channel, just asking to confirm. Thanks in advanced

asked by: Jonathan

0

Expert Reply:

The Conduit Clamp Set for Rhino-Rack Heavy-Duty Crossbars part # RRBC2 is designed for the Rhino Rack Heavy Duty Crossbars. The Rhino Rack Vortex Pipe Clamps for Conduit Carriers part # RRSPC4 are designed for Rhino Rack Vortex Aero Crossbars. The two are not cross-compatible as the channels are not the same.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

Yes, the Replacement Cover #PE48UV will indeed fit the 2018 Ford F-150 extended cab with the 67" bed. This is made to be a replacement cover for the Pace Edwards JackRabbit Retractable Hard Tonneau Cover #311-JRFA05A28 which is specifically for…

view full answer...

Answer 6

The 2" receiver for the EcoHitch item #EH87SR sticks out right through the middle of the air dam. I have attached a picture below that will show you what this front hitch looks like once installed. The EcoHitch Hidden Front Mount Trailer Hitch…

view full answer...

Answer 7

I spoke with my B&W representative who confirms that to install their GNRK1121 #BW77FR Turnover Ball hitch on a 2021 Ford F-150, the center of the 4 inch hole for the gooseneck ball would be placed 42-5/8 inches forward of the rear edge of the…

view full answer...

Answer 8

Shackle bolts have a nut that needs to get held with a wrench or socket while tightening them down. If you didn't use a wrench or socket when you initially installed the shackle bolts you could go back now with one so that you can tighten them…

view full answer...

Answer 9

In order to attach the Rhino-Rack Pioneer Platform to a set of crossbars you would need the kit that comes with universal mounts which is part #RR42114BF for 48" long x 37" wide or part #RR42115BF for 58" long x 47" wide. This…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...