Can The Dual LED Trailer Tail Light # CE86FR Be Used On The Driver And Passenger Sides

Question

Question:

with product # CE86FR is there a different light for passenger side and drivers side ?

asked by: John P

0

Expert Reply:

The Dual LED Trailer Tail Light - Stop, Turn, Tail, Backup - Red and Clear Lens # CE86FR has the wires directly in the center of the light allowing you to turn the light whichever way is needed depending on the side of the vehicle you're installing it on, therefore this light can be used on both sides.

expert reply by: Kevin C

0

Answer 1

That's correct, the Replacement Brake Shoes for Titan 12" Duo-Servo Hydraulic Trailer Brakes #T4862500 you reference is designed to fit with the left or the right hand side.

view full answer...

Answer 2

Selecting correct hydraulic drum brake assemblies for your tandem axle trailer requires matching brakes to the axle capacity, the size of your hub/drums (please see linked photo) and to the type of brake flange on your spindles. The linked page will…

view full answer...

Answer 3

In order to attach the Command Electronics Dual LED Trailer Tail Light - Stop, Turn, Tail, Backup - Red and Clear Lens #CE86FR to an aluminum surface you will want to use either a stainless steel, aluminum, or zinc plated screw like part #FA1131822.…

view full answer...

Answer 4

What you have there are the Command 003-20 incandescent tail lights. Although we do not have the incandescent replacement, we do have the LED version which is the #CE86FR. You will want to keep the lights the same way they are now with the brake…

view full answer...

Answer 5

Curt has a recommended setup procedure outlined for the Curt Echo part #C51180 that is outlined in their install instructions for this controller but since not all trailer brakes apply the same way there isn't a standard setting you can use that…

view full answer...

Answer 6

Thanks for the additional information and picture of the brake light on your 2020 Jayco Redhawk. I have a solution for you but those lights are attached to a single board and not able to be separately replaced or even repaired. The replacement light…

view full answer...

Answer 7

Hey Cory, thanks for reaching out! The Replacement Support Leg #TH33VK is for the 8-1/2" long Thule HideAway awnings which is what I believe will be a better match than the part #TH48VK you referenced, which is for a 10' long HideAway…

view full answer...

Answer 8

To replace your Phillips PC-301-A-1 Converter, I recommend the Progressive Dynamics 9300 Series RV Converter Charger #PD69RR. This is a 45 amp converter with virtually identical input/output as your old Phillips unit. You will have to add a…

view full answer...

Answer 9

Hey Tom, all of the lights you mentioned are bright and will easily be visible but the Command #CE44VR is the brightest compared to the part #DG52721PB and #DG52720PB.

view full answer...

Answer 10

Hey Jeremy, unfortunately the Reese 58351 lift tool is no longer available by itself. We used to carry them, but we sold our last one back in 2019. We do have some other similar lift tools available which may be suitable substitutes. The link below…

view full answer...

Answer 11

Without the VIN of your 2020 Jayco Redhawk, I cannot find out what lights came on your motorhome. If the lights on your motorhome measure 9-5/8" long X 7" tall X 5/8" deep, the Dual LED Trailer Tail Light - Stop, Turn, Tail, Backup -…

view full answer...

Answer 12

The Command Electronics Dual LED Surface Mount Light part #CE86FR can be installed on either side of a trailer. It does not have a left or right side designation. You would need to purchase 2 lights. Check out the review video I attached for more…

view full answer...

Can The Dual LED Trailer Tail Light # CE86FR Be Used On The Driver And Passenger Sides

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching