Compressor Recommendation for Firestone Ride Rite Air Helper Springs

Question

Question:

Compressor for my Firestone Ride Rite Helper Springs part number TMT 86 A

asked by: David V

0

Expert Reply:

For a compressor kit the heavy duty part # F2097 will work great to make inflating the Firestone bags and maintaining them easier. The compressor will inflate faster than standard compressors and the gauge inside the vehicle will allow you to monitor and inflate them from inside the vehicle.

expert reply by: Jameson C

0

Answer 1

The Firestone Air Compressor 24-3582-9210 is no longer available but we do have a suitable replacement for this, the Firestone Heavy Duty Air Compressor part #F9499. This is what Firestone recommends you use to replace the Firestone Air Compressor…

view full answer...

Answer 2

First take some soapy water and use that to spray on all the connection points to ensure that there is not a leak in the system. Then you will want to check the air filter that goes to the compressor to ensure that it is not clogged or damaged in…

view full answer...

Answer 3

I have a solution for you. However, the Firestone model no. 24-3582-9147 have been discontinued and there is no direct replacement for this model air compressor. I do have two compressors that will work for your application depending on your current…

view full answer...

Answer 4

Yes, you can replace the current Firestone standard duty compressor you have now with the part #F9284 and you'd be set. It would easily bolt right up and wire in place.

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 11

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Compressor Recommendation for Firestone Ride Rite Air Helper Springs

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching