Troubleshooting A Furrion Vision S Wireless Backup Camera System That Won't Pair

Question:

We received a replacement camera after original kept cutting out Boyle simple will not pair. I have the lights on and have the camera inside the vehicle connected to the monitor cable and both have power. Help! We are leaving in the morning and need this plworking. Furrion customer care is not taking calls!

asked by: Mary

Expert Reply:

The steps for pairing the monitor and camera of the Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen # FOS43TASF are as follows:

First ensure 12v power is running to both the monitor and the camera and that the blue pairing light is displaying. You can press and hold the pairing button on the camera for 10-15 seconds to get it to activate.

1. Use UP or DOWN button to highlight PAIRING menu, then press the power button to enter the next page.

2. Press the “MONITOR PAIRING” button at the bottom of selected camera to pair.

3. Once paired successfully, a red icon will appear after the device list.

4. An X icon indicates pairing failed, repeat steps 2 and 3 to pair again.

Since you're powering the monitor and camera in the cab of your vehicle there should be no voltage issue like you could experience when the camera is powered through the 7-way connector. If you go through these steps and still can not pair your camera then the monitor may be the issue and will need to be replaced. You can replace it with the 4.3" monitor # FR77FR, 5" monitor # FR97FR, or 7" monitor # FR47FR.