Mounting Instructions For The Excel RV Tankless On-Demand Water Heater

Question

Question:

Can this unit be mounted horizontally? Can it be installed where the RV water heater is being replaced?

asked by: Raybob

0

Expert Reply:

Per the manufacturer, Excel, the Excel RV Tankless On-Demand Water Heater - Gas - Electric Ignition - Ventless - 38,000 Btu # EX93FR has to be installed upright with the vent facing upwards. Other than that the only other installation restriction is to not install it in a bathroom or bedroom so you can install it wherever you have the space for it.

expert reply by: Kevin C

0

Answer 1

Yes, you could use a 1lb propane tank with the Excel RV Tankless Water Heater #EX93FR, but you would need to install a regulator and use the appropriate fittings. A 1lb propane tank will typically have a 1"-20 fitting so you would need to…

view full answer...

Answer 2

I apologize for the confusion but all of the tankless water heaters we offer like the Excel Water Heater part #EX93FR run off of propane and not natural gas. You would not have to convert anything to install this as it would work directly with your…

view full answer...

Answer 3

The Excel RV Tankless Water Heater #EX93FR has a 1/2" Male NPT fitting for its gas inlet.

view full answer...

Answer 4

If I correctly follow the installation you describe, yes this will be a workable installation. The Excel tankless gas water heater, #EX93FR provides hot water on demand. It is a vent-free design with an ODS (Oxygen Depletion Safety) shutoff device…

view full answer...

Answer 5

As long as you are able to mount the Excel RV Tankless Water Heater #EX93FR vertically in an area that is open it will work in your 1984 Holiday Rambler Aluma Lite trailer. As this unit is 14-5/8" there is typically not enough room to mount…

view full answer...

Answer 6

Because the Excel RV Tankless Water Heater #EX93FR uses propane it's not a great idea to use it in a small room like the bedroom or bathroom in the event that there was a gas leak. With these rooms being typically being smaller there's not…

view full answer...

Answer 7

Depending on how your plumbing is setup you could have a check valve at the water inlets and also in certain spots throughout the system. On my dad's fifth wheel he has specific valves he has to shut off or on depending on whether he's using…

view full answer...

Answer 8

There are a couple of things that you can do to get more ground clearance for your new trailer. First, if the leaf spring stack is attached under the axle then you could use an over/under conversion kit. If the trailer has a 2-3/8 inch diameter round…

view full answer...

Answer 9

The Excel Tankless water heater part #EX93FR is only available in a gas configuration with an electric ignitor. Due to the amount of heat needed to be created there isn't an electric only solution that can provide the amount of heat needed for…

view full answer...

Answer 10

The Excel RV Tankless Water Heater #EX93FR requires 3" of clearance on the sides and 8" of clearance above to allow for proper airflow. If your closet has enough room to allow for these clearance requirements then you can definitely mount…

view full answer...

Answer 11

Since the Excel RV Tankless On-Demand Water Heater - Gas - Electric Ignition - Ventless - 38,000 Btu #EX93FR doesn't have to be vented it can be mounted where ever you have the space to install it. Its overall dimensions are 11-5/8" wide x…

view full answer...

Answer 12

Because the Furrion RV Tankless Water Heater, model #FR93FR that you linked to, and other similar models, are most commonly mounted in compartments with exterior access doors that are not heated, the manufacturer recommends that they be winterized…

view full answer...

Mounting Instructions For The Excel RV Tankless On-Demand Water Heater

Product Page this Question was Asked From

Continue Researching