Could the Replacement Short Arm Assembly LC97UD Fit 2021 Jayco Eagle Travel Trailer

Question

Question:

Will this support arm fit a Solera electric awning on a 2021 Jayco Eagle model 334RLOK

asked by: Ted G

1

Helpful Expert Reply:

Yes, as long as your current arm measures 63 inches vertically when folded up the part # LC97UD would be the correct replacement.

expert reply by: Jameson C

1

Answer 1

When your current pitch arm is folded out and fully extended you will need to measure its overall length if it's 33 inches The Replacement Short Arm Assembly for RV Awnings #LC97UD will work for you it is 63 inches long and The Replacement Pitch…

view full answer...

Answer 2

I reached out to my contact at Lippert with the measurement of your support arm and they confirmed that the Replacement Short Arm Assembly for RV Awnings #LC97UD you were looking at is the correct replacement support arm assembly for your 2021 Jayco…

view full answer...

Answer 3

It's likely you need the Solera 63" Short Awning Support Arm part #LC97UD. In regards to finding a replacement, simply measure the length of the wall-mount extrusion from top to bottom. There are standard lengths; the short styles will…

view full answer...

Answer 4

The awning arms are measured from top to bottom of the wall mount. This can then be used to select the correct length replacement. I have attached a photo below to assist. You will also need to pay attention to the style of arms such as pitched or…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Yes, the Replacement Short Arm Assembly for RV Awnings part #LC404523 is correct for a Solera V000436372 Awning.

view full answer...

Answer 7

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Could the Replacement Short Arm Assembly LC97UD Fit 2021 Jayco Eagle Travel Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching