Replacement Motor and Control Module For Lippert CoachStep
Question:
I have a 2009 Monaco Camelot Class A Diesel Pusher. My step has stopped working so being that the RV is 13 years old I am thinking I should replace the entire step assembly motor and gear..... or do I just need a new stair motor and gear. My existing step is a Lippert LCI Model 165032, Serial # 527090, dated 03-19-08. What is the current replacement step that will fit my Camelot?
asked by: Brad M
Expert Reply:
You shouldn't need to replace the entire step assembly of your CoachStep, replacement parts should do the trick for you. As for the current replacement step, since CoachStep was discontinued some time ago, there isn't a specific replacement for these steps, you would need to measure the mounting bracket width and entry height. For example, if you had a mounting bracket width of 25-7/8" available and had an entry height of 23-1/4" - 25-1/4" you could install the Kwikee Electric RV Step Complete Assembly - Double - 40 Series - 24" Wide # LC3726892.
Having said that, since the steps just died, it seems likely it is the motor, or possibly the control module. If the motor is what is not working you can easily replace that with the Replacement Motor for Lippert Electric Coach Step # LC301695.
You can use a circuit tester to see if it is getting power, and if it is but the motor isn't working, you'll know the replacement will fix your issue. Otherwise, if it is not getting power, check the control module to see if it is powering the motor; if it is not then you can replace the module with the Replacement Control Module for Lippert Electric Coach Step # LC301702.
Products Referenced in This Question
Replacement Motor for Lippert Electric Coach Step
- Accessories and Parts
- RV and Camper Steps
- Motors
- Lippert
more information >
Replacement Control Module for Lippert Electric Coach Step
- Accessories and Parts
- RV and Camper Steps
- Control Module
- Lippert
more information >
Product Page this Question was Asked From
Kwikee Electric RV Step Complete Assembly - Double - 40 Series - 24" Wide
- RV and Camper Steps
- Motorhome
- Electric Step
- 24 Inch Wide Step
- 25-3/4 Inch Wide
- 2 Steps
- 8 Inch Drop/Rise
- No Ground Contact
- Steel
- Kwikee
more information >
Continue Researching
- Shop: Replacement Control Module for Lippert Electric Coach Step
- Shop: RV Furniture
- Q&A: Troubleshooting Controller Module for Kwikee Steps
- Q&A: Recommended Replacement Control Module For Frigette 202-3230 For RV Electric Steps
- Q&A: Solution for RV Step SCS/Frigette P/N 733-001 That Doesn't Fully Extend or Retract
- Search Results: lc3747453
- Search Results: 164889 controller
- Shop: Kwikee Electric RV Step Complete Assembly - Single - 36 Series - 30" Wide
- Shop: Rubber Top Lip Wiper Seal for RV Slide Out - Press On - 30' Long x 2-1/2" Wide
- Shop: Lippert SolidStep RV Steps for 29" to 36" Wide Doorways - 4 Steps
- Shop: Valterra RV Sewer Hose Carrier - Adjustable - 34" to 60" - Black
- Shop: Replacement Spacer Rivet for Fastway e2 Weight Distribution Head
- Shop: Vehicle Tow Bar Wiring
- Video: Lippert Electric Coach Step Replacement Door Switch Installation
- Video: Roadmaster Tow Bar Wiring - Splices into Vehicle Wiring - RM-154 Review
- Video: Lippert Components RV and Camper Steps LC301702 Review
- Q&A: Wiring Diagram for Installing Lippert Power Steps Module # LC301702
- Q&A: Troubleshooting Lippert Electric RV Step That Will Not Retract
- Q&A: Lippert Steps 128980 Wont Stop Retracting and Extending
- Search Results: 301702
- Search Results: 164889
- Search Results: motor for rv steps
- Search Results: rm~154
- Shop: Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Q&A: Wire Diagram for Lippert Power Steps for Troubleshooting Wiring and Power Module
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Base Plate for Tow Bar
- Search Results: base plates
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Wiring