Troubleshooting Brake Controller with Random Numbers Displayed when Override is Slid
Question:
When I push the manual break the numbers bounce around. Have no idea whats going on
asked by: Trenton W
0
Expert Reply:
You might try unplugging the controller and plugging back in to reset it. Also you might try some contact cleaner in the slot where the lever is and then slide back and forth quickly to try and clean out the contacts.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: 7-Pin Wiring Harness And Brake Controller For A 2024 Hyundai Santa Cruz
- Q&A: Trailer Hitch Receiver and Wiring Harness For a 2024 Hyundai Santa Cruz
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: 7-Way Trailer Wiring Harness for 2024 Hyundai Santa Cruz
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Which Wiring Harness Fits 2024 Hyundai Santa Cruz With Tow Package
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Q&A: Installing ETBC7 Kit On 2004 Toyota Tacoma TRD V6
- Q&A: Comparison of Tekonsha Prodigy P3 and Primus IQ Brake Controllers