Replacement Locking Knob Shaft for MaxxAir MaxxFan RV Roof Vents

Question

Question:

when turning the black knob, the vent housing will not open, like a piece is stripped out. are there replaceable parts for the opening knob operation?

asked by: Terry C

0

Expert Reply:

We do have the Replacement Locking Knob Shaft for MaxxAir MaxxFan RV Roof Vents, # MA10-21232KSHAFT.

expert reply by: Michael R

0

Replacement Locking Knob Shaft for MaxxAir MaxxFan RV Roof Vents_MA10-21232KSHAFT
(click to enlarge)

Answer 1

The Replacement Locking Knob Screw #MA10-21241K normally threads into the Replacement Locking Knob Shaft #MA10-21232KSHAFT which it sounds like you may be missing.

view full answer...

Answer 2

When installing the #MA10-20281K-1AF replacement operator, you might need to 'clock' the mechanism slightly which could take a little bit of trial and error, but the replacement operator does include installation instructions. I've…

view full answer...

Answer 3

The gear that you're talking about on your MaxxFan 4401K is the operator mechanism. For a replacement you need the #MA10-20281K-1AF.

view full answer...

Answer 4

There are not installation instructions available specific to the Replacement MaxxAir Roof Vent Manual Lift. I have attached an exploded diagram that shows the placement of the lift in the fan assembly for your reference.

view full answer...

Answer 5

The lift that you are speaking about (pointed out in the attached picture) for the MaxxAir MaxxFan Trailer Roof Vent #MA00-06200K is the interior trim, or otherwise known as the garnish. This is actually the piece that takes up the space that is from…

view full answer...

Answer 6

Unless the MaxxFan Deluxe Roof Vent #MA00-06200K is installed on your vehicle I wouldn't worry about a voltage regulator because the voltage will drop enough that you won't see a spike over 13.6V. If you do have the roof vent installed on…

view full answer...

Answer 7

The MaxxAir MaxxFan #MA00-06200K that you referenced is equivalent to a base model of the MaxxFan and it is only controlled by a keypad on the vent itself. If you wanted to connect it to your existing wiring then you would have to do some…

view full answer...

Answer 8

The fan of the MaxxAir MaxxFan Trailer Roof Vent w/ 12V Fan - w/ Rain Cover #MA00-06200K draws 5 amps. In theory a 750 amp battery would power this for 150 hours.

view full answer...

Answer 9

The MaxxFan Deluxe Roof Vent Fan and Thermostat, #MA00-06200K is a 12V DC, variable-speed fan has 2 modes of operation. In manual mode, 10 speed options let you increase or reduce airflow and in auto mode, fan turns on and off based on preset…

view full answer...

Answer 10

Sounds like you have a bad circuit board for your MaxxFan 6200 part #MA00-06200K which would require the replacement board #MA10A21276K.

view full answer...

Answer 11

The MaxxAir MaxxFan Trailer Roof Vent w/ 12V Fan - w/ Rain Cover - 14-1/4" x 14-1/4" - Smoke #MA00-06200K has a 10 speed, 12V fan as well as a built in thermostat. It is surely not just an exhaust fan and can even be used as a ceiling fan…

view full answer...

Answer 12

The MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat #MA00-06200K that you referenced needs a 12 volt power source so you are going to need to get 12 volts from the trailer's battery or circuit breaker panel so that it can operate. While the…

view full answer...