Making Under Hood Connections to Complete Trailer Brake Controller Install on a 2008 Chevy Silverado
Question:
I have the voyager xp #89240 And am tryin make sure I have the fuses in the right location and amp inside the fuse box.I have the wires by the fuse box crossed and bolted down and wired to the controller properly. It is a 2008 silverado LT
asked by: Paul
Expert Reply:
When making the under hood connections to install a brake controller on a 2008 Chevy Silverado, you just have to make sure you have everything in the proper location. We actually have an FAQ article which I have linked for you that covers the under hood connections and shows you where everything goes.
The wire for power to the brake controller is located to the right of the power distribution box. The wire will attach to the left most terminal at the front of the power distribution box. The wire for 12 volt power is located beneath the power brake booster. It will go to the far right terminal at the front of the box.
The fuses for these terminals should already be present but if they are not place a 30 amp fuse in the location nearest the brake controller power wire and a 40 amp fuse in the spot closest to the 12 volt power wire terminal. Or use the legend on the lid to be sure of the correct locations.
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: Best Camper Jacks
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)