What Is The Derale Snap-In Radiator Adapter Fitting Made Of

Question

Question:

The D13035 in the how to videos was once metal. How strong and resistant to heat is the revised plastic replacement?

asked by: Steve K

1

Helpful Expert Reply:

The Derale Snap-In Radiator Adapter Fitting for GM # D13035 you reference is in fact made of aluminum, and is just as strong and resistant to heat as before.

expert reply by: Bryce D

1

Answer 1

Hey Tarek, for your 2023 Ford Raptor I recommend checking out the Timbren Suspension Enhancement System #T75MR. This suspension enhancement system has a load leveling capacity of 3,000 lbs, will increase stability while reducing sag, and will install…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

We have both single and dual ramp spring sets and form my understanding it has more to do with the weight capacity than anything else. For your 85 lb ramp we have the Single Spring #362SA5 that fits a 5' wide enclosed trailer. Aside from that I…

view full answer...

Answer 6

You can install a stack cooler in your vehicle. The Class ratings are there as a reference point to a hitch Class. For example if someone has a Class III hitch they can look at coolers, see a Class III and say, hey, I have a Class III hitch so this…

view full answer...

Answer 7

Given the weight of your trailer and the fact that you tow uphill I recommend going with the largest cooler or most efficient that will fit in the available space you have in the engine compartment of your 2004 Silverado. A stacked plate cooler is…

view full answer...

Answer 8

For the 4L80E transmission that is in your 2002 Chevy 2500HD Silverado we have supplemental transmission coolers that would work great in conjunction with the factory cooler or as a stand alone cooler if you are looking to bypass the factory cooler.…

view full answer...

Answer 9

For a towing application adding a supplemental transmission cooler to your 2008 Chevy Tahoe 5.3L V8 is an excellent way to reduce thermal stress and help prolong the life of your transmission. The OEM cooler (built into the radiator) is meant for…

view full answer...

Answer 10

The distance from the hitch pin hole to the edge of the bumper on the #DT73RR will be approximately 6" so I don't think that 1Up rack would work. They don't list measurements but the shank on the bike rack doesn't look very long at…

view full answer...

Answer 11

I would start by determining the towing capacity of the vehicle. I did some research, and saw a range of 2000-5200 lbs depending on how the vehicle was equipped. If you phone your Chevy dealer, they should be able to tell you the towing capacity of…

view full answer...

What Is The Derale Snap-In Radiator Adapter Fitting Made Of

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching