Trailer Wiring Harness Compatible with Peterson 435800 Trailer Stop/Turn/Taillight
Question:
What new 3 way wiring kit would go with the Peterson Trailer Light Kit Item #435800?
asked by: Francis A
Expert Reply:
We don't offer a plug and play trailer harness that would plug directly into the Peterson # 435800 trailer taillight.
The lamp includes a 3 pin pigtail that would plug into the rear of the lamp which would wire directly into the trailer wiring.
If you need a 4 pole harness for your trailer, we offer them in varying lengths.
• For a 20 foot harness, use part # A20WB
• For a 25 foot harness, use # A25W2GWB
• For a 30 foot harness, use # HM48265
• For a 35 foot harness, use # A35W42B
To make the wiring connections, I'd recommend using heat shrink connectors like part # DW05743-10.
Products Referenced in This Question
20 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 30" Ground
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 11 - 20 Feet Long
- Plug and Lead
- 4 Flat
- Optronics
more information >
25 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 25' Ground
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 21 - 30 Feet Long
- Plug and Lead
- 4 Flat
- Optronics
more information >
35 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 42" Ground
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 31 Feet and Longer
- Plug and Lead
- 4 Flat
- Optronics
more information >
Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation - Red - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 22-18 Gauge
- Deka
more information >
Hopkins Endurance 4-Way Flat Trailer Wiring Harness - 30' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 21 - 30 Feet Long
- Plug and Lead
- 4 Flat
- Hopkins
more information >
Product Page this Question was Asked From
Peterson Trailer Tail Light w/ Grommet and Plug - Stop, Turn, Tail - Incandescent - Round - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 4-1/4 Inch Diameter
- Red
- Peterson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement for Signal Stat 9031 Trailer Light Assembly
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Replacement Tail Light For Demco Kar-Kaddy KK360 and KK260 Tow Dollies
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Solution for Replacing Dexter 8-222 Trailer Hubs and Bearings
- Q&A: Should Ground Wire of Trailer Wiring Run to Frame of Trailer or Back to Light Assemblies
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Parts Needed To Make A 7-Way Round Pin Extension
- Q&A: Diagrams For Wiring 3-Axle Trailer With Brakes, Breakaway, And Lights
- Q&A: Does The etrailer Invisible Base Plate Kit # e86YR Need An Adapter For A Blue Ox Aventa II Tow Bar