What is the Mounting Hole Pattern for Galvanized 10 Inch Marine Trailer Brake Assembly 40715
Question:
what is the on center of bolt holes measurment on backing plate on 40715
asked by: Chris S
0
Products Referenced in This Question
Brake Mounting Flange for 2-3/8" Round Axle
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- Electric Drum Brakes
- Hydraulic Drum Brakes
- Brake Mounting Flange
- 10 Inch
- 2-3/8 Inch Diameter Axle
- Redline
more information >
Product Page this Question was Asked From
Demco Hydraulic Drum Brake Assembly - Free Backing - Galvanized - 10" - Right Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- RH
- 3500 lbs
- Brake Assembly
- Free Backing
- 10 x 2-1/4 Inch Drum
- Demco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: L68810 Bearing Recommendation for a L68149 Bearing
- Q&A: Grease Seal for Spindle that is 1.68 Inches in Diameter
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: ST205/75r14 Trailer Tire Vs. a ST205/75D14
- Q&A: Is It Worth It To Convert Surge Brakes On 1999 Jayco Eagle To Electric, Or Get New Surge Brakes?
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Q&A: How to Determine Which Drum Brakes to Get
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure a Trailer Axle
- Article: How to Choose a High-Low Adapter
- Article: Can You Flat Tow a Ford Ranger
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)