Installation of the Jack-It 2 Bike Rack for A-Frame Trailers With Powered Jack
Question:
Is there a video to show how to install the Jack-It bike rack, so I can see how the wire is moved when installed?
asked by: Duane E
0
Expert Reply:
Yes, the Jack-It 2 Bike Rack for A-Frame Trailers, # LC429756, does have an installation video, but not on a trailer with a powered jack. Please note the link to video below and jump and to about the 5:38 mark. You will need to disconnect the wires for your powered jack and feed them through as well. This is the only difference for installation between a powered jack and a manual crank type.
expert reply by:
Michael R
0
Continue Researching
- Article: How to Carry Bikes While Towing a Travel Trailer
- Q&A: Bike Rack Recommendation for NuCamp 320 Camper
- Q&A: Recommended AC With Heat Strip for Enclosed Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Bike Rack Solution for Carrying Bikes between Tow Vehicle and Camper
- Q&A: Straight Stinger for Jack-It 2 Bike Rack for A-Frame Trailers
- Q&A: Orientation of Jack-It 2 Bike Rack for A-Frame Trailers Installed on Camper Trailer
- Q&A: Fitment of the Hitch-It 2 # LC731138 to a 10" Straight Trailer Tongue
- Q&A: Converting a Hymer Touring GT Camper from Surge to Electronically Controlled Brakes
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps