Do the Links of a Weight Distribution System Represent Tongue Weight

Question

Question:

Are the multiple tongue weight ratings associated with each additional link pulled up to the brackets? For instance if 7 links equal 500 lbs TW then 6 would be 600 lbs 5 would be 700 lbs

asked by: Tom

0

Expert Reply:

The individual links on a weight distribution system like the # RP66541 do not represent different tongue weight values. It really just comes down to following the setup procedure that is outlined in the install instructions which are attached which basically comes down to using enough spring bar tension to allow the tow vehicle to sit level.

It is not required to know the tongue weight beyond making sure the system you pick out has correct range for the tongue weight of the trailer when loaded.

expert reply by: Jameson C

0

Answer 1

Hi Bill, The Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA92-00-0450 has a tongue weight range of 200lbs - 450lbs so you'd be right around the middle of the capacity when loaded, making this a great choice. This doesn't come with…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

From a legal standpoint Optronics LED Clearance or Side Marker Light #00212336P would not meet any reflector requirements. If you like this light though you can get a separate reflector. I have included a link to the reflector-only options that we…

view full answer...

Answer 4

In regards to selecting the correct weight distribution system, the loaded tongue weight of the trailer is not the only figure that goes into this. The weight of any cargo stored behind the rear axle of the tow vehicle needs to be added in as well.…

view full answer...

Answer 5

I have two options that will allow for you to extend the connection point between your truck and trailer. The best option for you will depending on the gross trailer weight (GTW) and tongue weight (TW) of your trailer. As long as the GTW and TW of…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

As long as you are backing up mainly in a straight line you can back up with a weight distribution system like the Curt part #C17051 that you referenced. If the angle of the truck and trailer would get more severe than what you would experience while…

view full answer...

Answer 8

Since your 2017 Chevrolet Traverse does not have the factory connector but does have a rear air conditioning unit I recommend first checking to see if you have the factory tow package. You can locate the plug for the Tekonsha T-One #118270 at the…

view full answer...

Answer 9

Weight distribution systems are only available for vehicles with a Class III or higher rated hitch with the 2 inch receiver, not the 1-1/4 inch receiver on a Class I or Class II hitch. Your best bet would be to replace your existing hitch with a…

view full answer...

Do the Links of a Weight Distribution System Represent Tongue Weight

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching