Is Replacement 3-Wing Hand Knob for Thule Carriers Item # 753-0745 Sold Individually

Question

Question:

Replacement 3-Wing Hand Knob for Thule Bike, Board and Ski Carriers Item # 753-0745 How many come with this? Is it one because the pictures look like you get a bag of them.

asked by: Carrie

0

Expert Reply:

The Replacement 3-Wing Hand Knob # 753-0745 that you referenced is sold individually. The one customer who had a bag of these delivered had ordered several of them.

expert reply by: Jameson C

0

Answer 1

Yes, the wing nut #753-0745 that you referenced does fit the M6 bolt size.

view full answer...

Answer 2

The threads on the Replacement Square Head Bolt for Thule Fairings, #853-208909, are an M6 bolt. I pulled the bolt and wing nut #753-0745, and tested them together. The bolt threaded in the nut correctly so it is an M6 bolt and knob. The bolt head is…

view full answer...

Answer 3

If you unlock and remove the old lock core then the knob should then just spin off and you can repeat the same steps to install the new knob, Replacement Locking Knob for Thule Bike Racks part #TH79JV. Please note, you will need the change key to…

view full answer...

Answer 4

Yes the thread size of the knob part #TH79JV is M8 so it is perfectly compatible with the T-bolt part #853-0782 that you referenced.

view full answer...

Answer 5

The threaded portion of the Replacement Locking Knob for Thule Bike Racks #TH79JV is M8.

view full answer...

Answer 6

Yes, there is a nut inside of the knob part #753-0745 that fits a m6 bolt confirmed by a test fit. I have attached a photo that shows the nut inside of the knob a bit more clearly.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...