Replacement Clevis Pin Recommendation for a Blaylock EZ Lock Trailer Coupler Lock

Question

Question:

I do not need this product. I have one already. But, this product has a pin that I am looking for to use on a 2 inc receiver to lock my htich/ball with my own lock. I am looking for a hitch pin but the same type pint that this uses where you can put a standard lock on the end of the pin. I have multiple trailers and currently only have one pin like this that allows me to lock the hitch/ball to my vehicle with a lock that I use this way all of my locks have 1 key... the lock for the pin on the vehicle, the lock on the trailer hitch to the trailer, etc. I have supplied a picture of the one I have now. Would you have such a pin?

asked by: Stephen

0

Expert Reply:

Yes, you would want a Replacement Clevis Pin # BL040CPIN-TL3350. This is the replacement pin for the Blaylock EZ Lock Trailer Coupler Lock # BLTL-33 that you referenced.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Progressive Dynamics RV Power Control Center #PD4135K is going to be the closest in dimensions to replacing the Magnetek model 80 power center you have. This control center fits inside a 10-1/4" long x 7" tall cutout and is 11-1/4"…

view full answer...

Answer 2

I have a different option for you, but the Progressive Dynamics #PD4635LIV you were looking at is a replacement for the WFCO 8935 and not your WF-8735P. Instead you will need the Progressive Dynamics #PD4135K which is designed to replace your…

view full answer...

Answer 3

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

view full answer...

Answer 4

Yes, all you'll need to do is disconnect the three wires running from the converter section in your Progressive Dynamics 4100 #PD4135K from the AC distribution panel (circuit breaker, ground bus bar, neutral bus bar). This will cut the power…

view full answer...

Answer 5

Yes, the Redarc Tow Pro Liberty part #RED52VR can install in your 2023 Ford Ranger that has the factory 7-way. It would wire directly to the brake controller install wiring that is present under the dash.

view full answer...

Answer 6

Sure thing! The EZ Lock Trailer Coupler Lock #BLTL-20 is for Bulldog Collar-Lok-style couplers while the EZ Lock Trailer Coupler Lock #BLTL-33 is designed for Fulton, Shelby, Dutton-Lainson, Atwood, and similar couplers. I've attached some review…

view full answer...

Answer 7

It is possible to move a trailer by just attaching to it's safety cables. Most people would avoid the method you described as the trailer will slam into the back of the tow vehicle while stopping. Basically it wouldn't be a thief's ideal…

view full answer...

Answer 8

If the front part of your square-bodied coupler is approximately 3 inches tall, based on the inner dimensions of the lock the Blaylock EZ Lock Trailer Coupler Lock #BLTL-33 will work well for you. The #BLTL-33 has inner dimensions of 3-1/8 inches x…

view full answer...

Answer 9

You would want to weld the Brophy Safety Chain Mounting Bracket part #MB38 to your trailer, then you would use the quick link part #C82932 to attach the safety chains part #C80176 to your trailer.

view full answer...

Replacement Clevis Pin Recommendation for a Blaylock EZ Lock Trailer Coupler Lock

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching