How Far Back Does the Receiver Tube Go On the Curt C25VR?

Question:

What is the distance between the centerline of the pin hole, and rear face of the 2inch hitch receiver tube? I need this to see if the hitch will work with my bike rack. Thanks

asked by: Chris S

Expert Reply:

I had the Curt # C25VR measured and from the center of the pin hole to the back of the receiver tube will be 3 inches. As long as the shank on your bike rack does not exceed 3 inches past its pin hole, you will be good to go. I will say that most racks will not have shanks that extend that far, but if your racks does, it could be trimmed down if needed.

expert reply by: Lazer S