Replacement Friction Discs for Fulton K1550 Brake Winch

Question

Question:

I have a fulton k1550 winch. I need new friction discs. manual calls for #1588S00 which appears to be unavailable. Is there a suitable replacement? If that is not possible I need a recomendation on a cable brake winch 2500 lbs.

asked by: David

1

Helpful Expert Reply:

There is indeed a suitable replacement.

The Fulton 1588S00 was replaced by the # F501115 which we carry. They are sold in a quantity of 2.

expert reply by: Mike L

1

Answer 1

Yes, the Dutton Lainson winch part #DL14934 is a brake winch like what would work great for raising and lower a Ham radio tower. This is the style that most people use so it would be a great option. For a cable you would want the part #DL24045.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the 1-1/2" Square…

view full answer...

Answer 6

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 7

Based on the information I could find the Samsung MR1031UWC is a countertop style microwave that is 20-11/32" wide, 13-11/32" tall and 14-5/8" deep. Currently we only have over the range and built in style microwaves. If your microwave…

view full answer...

Answer 8

Hey Roger, yes you could remove the trim of the High Pointe Built In Microwave part #HP84ZR and it could sit on a counter top like you asked about. The dimensions listed for it are correct for without the trim kit: 19" W x 11.375" H x…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement Friction Discs for Fulton K1550 Brake Winch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching