Replacement Wheel Studs for 13 inch Kodiak Hub/Rotors
Question:
I need to replace the 1/2 inch studs in my Kodiak 13-inch rotors. I found part numbers for the smaller brake rotors, but nothing to match the 7k axle rotors. Do you have a part number for these?
asked by: Ron H
0
Expert Reply:
For 1/2 inch wheel studs for Kodiak hub/rotors we have the Kodiak wheel stud part # K12WB2 which is what you'd need.
expert reply by:
Jameson C
0
Products Referenced in This Question
Kodiak Wheel Bolt - 1/2" Diameter x 2" Long
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 1/2 Inch Diameter
- Drive-In Stud
- 2 Inch Long
- Kodiak
more information >
Product Page this Question was Asked From
Kodiak 13" Hub and Rotor - 8 on 6-1/2 - Raw Finish - 1/2" Bolts - 7,000 lbs
- Trailer Hubs and Drums
- Hub with Integrated Rotor
- Standard
- 25580
- 14125A
- For 7000 lbs Axles
- 1/2 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Kodiak
more information >
Continue Researching
- Q&A: Disc Brake Pad Cross Reference for Kodiak 250 Caliper
- Q&A: What are the Measurements for Replacement Rubber Bushing for Kodiak Guide Bolt Sleeve
- Q&A: Replacement Drum Assemblies for AL-KO 8490 Hubs
- Q&A: Replacement Grease Cap and Wheel Studs for a RV Trailer Hub with ALKO Electric Brakes
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Q&A: Equalizer Upgrade Kit For Keystone Raptor With 33 Inch Axle Spacing & 7 Inch Equalizers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Performance Chips and Modules
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Types of Trailer Hitches: How and Why to Use Each