Which SnapPad for 2021 Heartland Big Country with Lippert Ground Control 6 Point

Question

Question:

what size pad on a new 2021 heartland big country with lippert 6 point hydraulic lift

asked by: R H

1

Helpful Expert Reply:

For your 2021 Heartland Big Country that has the Lippert 6 Point Ground Control system the correct SnapPad set you'd need is the part # SP54FR6.

expert reply by: Jameson C

1

Answer 1

We do not carry any lug nuts with a rubber gasket and I personally would not recommend using any rubber gaskets for lug nuts. The hubs on your 2018 Jayco North Point will generate a lot of heat from the brakes. This would cause the rubber to become…

view full answer...

Answer 2

SnapPads like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 6 Item #SP54FR6 can be taken off and on as needed so you won't have to keep replacing them every time you need to take them off.

view full answer...

Answer 3

We do offer the 9" snap pads like SnapPad Jack Pads part #SP54FR6. Depending on whether you have a 5th wheel or a motorhome there is a slight difference between them but I would be happy to help you select the correct ones if you provide that…

view full answer...

Answer 4

For attaching the JT's Strong Arm Jack Stabilizer Kit #LC191023 to front landing gear the needed brackets are included. I attached a picture that shows how these install to landing gear jacks on the front of a trailer as well as an install video…

view full answer...

Answer 5

Yes, when mounting the JT's Strong Arm Jack Stabilizer Kit #LC191023 it is acceptable to mount to the steel belly pan of the front compartment. Lippert does list this as an acceptable mounting location in the installation manual Step #2 that I…

view full answer...

Answer 6

The SnapPad Jack Pads, #SP54FR6, is for round feet pads at 9" in diameter. Please measure the diameter of the feet on your RV for fitment.

view full answer...

Answer 7

Can you send me a picture of the feet of your jacks? How far apart are they?

view full answer...

Answer 8

I can see why this might be confusing but the information on page 19 that you're seeing is in regards to cookware that did not come with the Furrion Over-the-Range Convection Microwave #FMCM15SS. The wire shelf is designed to be used during…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Which SnapPad for 2021 Heartland Big Country with Lippert Ground Control 6 Point

Product Page this Question was Asked From

Continue Researching