How Does Breakaway Switch Normally Wire to Trailer Wiring
Question:
With the Zip two wire breakaway switch, one wire goes to the terminal in the Bargman 7pin box for the trailer brakes blue wire from TV harnes. Where do I connect the other wire to receive power from the TV battery? Thanks for any help.
asked by: John M
0
Expert Reply:
One of the wires that runs to a trailer breakaway switch goes to the brake output circuit of the trailer wiring which is what activates the trailer brakes and the other wire runs to the breakaway battery output wire which both of these wires are typically blue but not always. I attached a diagram that shows how it all gets connected.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger - Side Load - 7" Wire
- Trailer Breakaway Kit
- Kit with Charger
- Side Load
- Single-axle
- Tandem-axle
- LED Tester
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Brake Assembly for B12EA-22 on 2018 Forest River 294BH Travel Trailer
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Fit of Turnoverball Underbed Gooseneck Trailer Hitch # BWGNRK1313 with my 2006 Dodge 3500 8 Foot Bed
- Q&A: Will Firestone Air Bags Interfere if I Install a B&W Gooseneck Trailer Hitch for a 2004 Dodge 2500
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Dexter P-15 SLR Axle SN D4484069 Weight Capacity and Replacement Axle
- Q&A: Weight Capacity of Dexter P-12 Model SLR Axle
- Q&A: Installation Instructions For Hopkins Engager Trailer BreakAway Kit
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Hitch Receiver Sizes
- Q&A: Replacement for Atwood Yoke Style A-Frame Coupler For 2 Inch Hitch Ball