Bolt Hole Spacing of Curt C13180 Class III Hitch
Question:
I have a Master Lock receiver that needs replaced. The numbers on it are S0137 and 2863AT. The holes I drilled are 14 inches apart. I really dont want to put new holes in the frame. What is the bolt placement? Also is it required to drill in the bumper for those bolts? Thank you.
asked by: Tim R
Expert Reply:
I cannot find any reference to the part numbers you provided online. The Curt # C13180 Class III receiver hitch is a confirmed fit for the 2000-2006 Toyota Tundra.
If you're needing the bolt hole spacing of the # C13180 that you'd looked at, I've provided a photo showing the bolt hole spacing. The dimensions shown are measured center to center.
If you aren't speaking of a trailer hitch, let me know.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Front Mount Hitch
- Shop: Camco RV Drain Valve w Flange for 1/2" or 3/8" Diameter Drain Hose - Barb Thread
- Shop: Dometic RV Water Heater - Gas and Electric - Automatic Pilot - 120 Volt - 10,000 Btu - 6 Gal Tank
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Camco Water Heater Drain Valve Replacement - 1/2"
- Q&A: Mounting Hole Dimensions for the Curt Trailer Hitch Receiver # 14053
- Q&A: Distance Between Mounting Flanges on Draw-Tite Class IV Hitch Part Number 37130
- Q&A: Flange Diameter of Camco RV Drain Valve
- Q&A: Mounting Flange Length for the Curt Hitch part # 14053
- Q&A: Distance Between Mounting Holes of the Curt Hitch 14053
- Q&A: Draw-Tite 75715 Hitch Mounting Holes Will Not Line Up On A 2012 Nissan NV 2500
- Search Results: 15920
- Search Results: shower curtain track
- Q&A: Recommendation to Replace Factory Trailer Hitch on a 2003 Toyota Tundra
- Shop: Trailer Wiring
- Search Results: hitch
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer hitch
- Shop: Suspension Enhancement
- Article: My Trailer Hitch Doesn't Fit
- Video: Choosing the Right Brake Controller
- Search Results: brake controller
- Shop: Gooseneck Hitch