What Size Thread Tap Would Be Needed for Install Hardware of etrailer Hitch e98857
Question:
I’m considering getting a tap to clean the factory holes in the frame of my vehicle before installing the trailer hitch. What size bolts are used and what tap should I use to do this?
asked by: Kelsey A
0
Expert Reply:
The etrailer hitch part # e98857 that you referenced comes with bolts that are sized M10-1.25.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Visible Cross Tube
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Determine if 2006 Toyota Highlander Has the Factory Tow Package
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: Install Video that Can be Used for 2007 Toyota Avalon for Trailer Wiring
- Article: How to Measure a Trailer Axle
- Q&A: Reliable Trailer Wiring Recommendation for 2004 Toyota Highlander
- Q&A: Recommended 4-Way Wiring Harness for a 2023 Ford Bronco Sport
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Towing Capacity and Parts Needed for 2006 Lexus RX 400h
- Article: Trailer Hitch Receiver Sizes