TracRac TracONE Ladder Rack Replacement Strip

Question

Question:

I have a TracRac One truck rack and Id like to order new rubber strips to fit in the top channel of the 65inch cross bars. I found an article on your site that mentions your Replacement Rubber Strip for Thule Aero Load Bars 53inch Item # TH853354407 might work. Can these be cut to fit the full length of the 65inch bars? Here are a few pictures of my set up. Thank you!

asked by: John M

0

Expert Reply:

The channel on the TracRac TracOne Ladder Rack is not the same size as the channel on the Thule WingBar EVO. So that strip will not work. You need Rubber Wear Strip for TracRac Crossbars - 30" Long, part # TARX-12007-1. It is a 30" weather strip designed to fit your TracRac TracONE Ladder Rack.

expert reply by: Mark Smith

0

Answer 1

The width of the slot gap in the Thule ProBars that uses the Replacement Upper Rubber Cover Strip for Thule ProBar Crossbars #TH97JH is 1/2 inch. The overall width of the channel is 3/4 inch.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Shannon, thanks for reaching out! Sounds like you're looking for the Thule Xsporter Pro #TH500XTB-THXK3 for your 2008 Toyota Tacoma with the Deck Rail System. This is adjustable up and down as well as along the Deck Rail System so you get the…

view full answer...

Answer 4

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 5

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 6

Hey Angela, If you're wanting a ladder rack then I recommend the Thule TracRac TracONE Ladder Rack #TH27000XTB-TA. This rack comes with load stops that you could use to secure your paddleboards or you could go with a track mounted carrier like…

view full answer...

Answer 7

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The only difference between the #RG06-050 and Timken #TMK58ZR is the brand and quantity. Timken is typically considered to be a high quality brand, particularly for their USA made bearings. The #RG06-050 comes with two seals so it is the better…

view full answer...

TracRac TracONE Ladder Rack Replacement Strip

Product Page this Question was Asked From

Continue Researching