Which Mount Is Required For Opti-Brite LED RV Dome Light ILL29CB?

Question

Question:

Need item # and price for mount on light ILL29CB and a picture

asked by: Ed K

0

Expert Reply:

The Opti-Brite LED RV Dome Light - 500 Lumens - Grommet Mount - 4" Round - Clear Lens # ILL29CB you were looking at gets mounted in a 4" round grommet # A45GB.

This will require a 4-1/2" cutout in the surface you are mounting the light.

For the most up-to-date pricing information just click on the included links to be taken to the product page which has the price shown just above the add to cart button.

I included videos for both of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

The diameter of the receiving hole of the Pivoting Door Holder Receiver #37210635 is 9/16" of an inch. It is not meant to work on older featherlite horse trailers for the down window as a keeper, is it a replacement part for the Pivoting Plunger…

view full answer...

Answer 2

To remove the lens on the Glantastic LED RV Dome Light part #328-K-58L349 you will gently pull and twist on the lens until it pops off. This is separate from the base and will take a little force. Check out the attached photo which shows the raised…

view full answer...

Answer 3

The Opti-Brite LED Sealed Dome Light Item #ILL46CB does not have touch capabilities. It would have to be wired into a circuit that is on a switch. We have some lights that are touch activated: 12 inch long #XIL-ST12 7-1/2 inch long #XIL-ST75

view full answer...

Answer 4

There is very little difference between the two. Both hub/drums are for a 7K axle, and have an 8 on 6-1/2 inch bolt pattern with 1/2 inch wheel studs. Either hub/drum includes the bearings, races, grease seal, lug nuts and E-Z Lube dust cap. The…

view full answer...

Answer 5

If the vent fan you have now is reversible then there should be a button on the assembly next to the other controls. However, if the fan is not reversible then all you need to do is reverse the wires on the motor (not the circuit board) and that will…

view full answer...

Answer 6

Building your own is always a fun project, we appreciate the opportunity in supporting our neighbors with their needed parts and components; we ensure this is always done with quality parts supplied by the OEM. Please visit the Customer Service tab…

view full answer...

Answer 7

We have the Ceiling Garnish for Fan-Tastic Vents Roof Vent with 6" leg in White, #FVK1060-81. The garnish in black is, #MA10-20209. 4-1/4" leg in white is, #VA0445-28. 4-1/2" leg in off white is, #FVK2040-80. 5" to 5-5/16" in…

view full answer...

Which Mount Is Required For Opti-Brite LED RV Dome Light ILL29CB?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching