Parts Needed To Replace 12" Keel Roller That Fits 1-5/16" Diameter Pipe
Question:
Hello, I have an old EZ loader boat trailer that needs a 12” long keel roller, but the roller goes on a pipe which is 1-5/16” diameter. Are there any keel rollers available with this pin hole diameter? A longer roller could also possibly work.
asked by: Eric
Expert Reply:
I have another option for you, but we do not currently carry any Keel Rollers that would fit a 1-5/16" pipe.
Instead I recommend going with the Yates Keel Roller for Boat Trailers - Super-Heavy-Duty Rubber - 12" Long - 5/8" Shaft # YR12244-125EC you were looking at and then adding the correct bracket # CE10305G and shaft # CE10727A to your trailer.
This will allow you to use a standard keel roller, and make finding replacements now and in the future much easier.
I included videos of the products mentioned for you to take a look at.
Products Referenced in This Question
CE Smith Panel Bracket for 12" Boat Trailer Rollers - Galvanized Steel
- Boat Trailer Parts
- Rollers
- Roller Bracket
- Galvanized Steel
- CE Smith
more information >
Roller Shaft with Pal Nuts for Boat Trailer Rollers - Zinc-Plated Steel - 13" x 5/8"
- Boat Trailer Parts
- Rollers
- Roller Shafts
- 5/8 Inch Diameter
- Zinc-Plated Steel
- 13 Inch Long
- CE Smith
more information >
Product Page this Question was Asked From
Yates Keel Roller for Boat Trailers - Super-Heavy-Duty Rubber - 12" Long - 5/8" Shaft
- Boat Trailer Parts
- Rollers
- Keel Roller
- 3-3/4 Inch Diameter
- Black Rubber
- 11-3/4 Inch Long
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does The Redline Grease Seal 13194 Have Markings Of TCM 13194 TM and a Spring On The Inside Lip
- Q&A: Recommended Keel Rollers to Replace Worn Rollers on Boat Trailer
- Article: How Level Should a Tow Bar Be When Flat Towing
- Q&A: Differences between Yates Keel Rollers # YR12000 and # YR12244-125EC
- Q&A: Center Diameter for 12" Long x 3-3/4" Diameter Yates Keel Roller for Boat Trailers
- Q&A: Should Keel Rollers Touch the Bottom of the Boat
- Q&A: Is 90 PSI Rating for 4.80-12 Size Tire Too High
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Measure for Trailer Hitch Drop
- Article: Where to Position the Trailer Axle?