Replacement Grease Cap for an AL-KO 8490 With EZ Lube Spindles
Question:
I need a grease cap I do have the grease fitting witch part do I need Thank you
asked by: Ed
0
Expert Reply:
From what I could find out about your AL-KO 8490 hubs, they us a Dexter #84 spindle. This is one of the most common 3,500 pound options out there, so I can confirm the TruRyde Grease Cap, 1.99" OD EZ Lube Drive in with Plug # RG04-040 will fit without issue.
Depending on how your bearings and seals are looking, you may also consider looking at the Bearing Kit for #84 Spindle # BK2-100. This will replace both races, both bearings, and the seal.
expert reply by:
Lazer S
0
Products Referenced in This Question
Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44649 and L68149
- Race L68111 and L44610
- 3500 lbs Axle
- etrailer
more information >
Product Page this Question was Asked From
Grease Cap, 1.99" OD EZ Lube Drive in with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- E-Z Lube Grease Cap
- 1.99 Inch O.D.
- TruRyde
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Which Grease Cap Fits Dexter Trailer Hub and Drum Assembly for 8,000-lb E-Z Lube Axles
- Article: How to Measure a Trailer Axle
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Replacing Slipper Springs Incorrectly Installed on 18' Boat Trailer With Double Eye Leaf Springs
- Q&A: Timken Bearing Kit Fitment for a 3,500 lb Axle
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Replacement Bearings for My 2000 Haulmark Enclosed Trailer
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement