Recommended Locking Hitch Pin For Curt RockerBall Towing Kit # C63KR

Question

Question:

Is the Curt Rockerball hitch kit, C63KR, available with a 2inch and locking hitch pin?

asked by: Jim H

1

Helpful Expert Reply:

The Curt RockerBall Anti-Rattle Towing Kit - 2" Ball - 8-1/4" Long Mount - 7,500 lbs # C63KR you were looking at has a 2" hitch ball with a 7500lb towing capacity, and for a locking hitch pin you can use the etrailer Trailer Hitch Receiver Lock for 2" Hitches # e98880.

This will replace the anti-rattle hitch pin and plate, so for an anti-rattle device you can also add the etrailer Anti-Rattle Hitch Stabilizer # e99007 to keep the hitch from rattling in your trailer hitch receiver.

I included a few video reviews and a link to the written instructions of the # C63KR for you to take a look at.

expert reply by: Samuel C

1

Answer 1

The Curt Rockerballs like the #C63KR will not interfere with your surge brakes. The movement they allow would not prevent the inertia of your vehicle applying the brakes from activating your surge actuator.

view full answer...

Answer 2

Having a ball mount that is longer should not be an issue. It actually can provide more clearance when turning. The standard for a 2 inch ball mount is around 8 to 8-1/2 inches from the center of the hitch pin hole to the center of the ball hole. We…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

To keep your back end from squatting, I recommend the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension item #CSS-1094R. These insert into your rear springs and keep your suspension from being pushed down by the weight of your…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Just looking at your Tern HSD bike with fenders, I'm going to say no the Saris MHS Bike Rack for 1 Bike #SAR23MR is not going to work. I did some research and it looks like a lot of Tern owner's went with the Hollywood Racks Sport Rider SE…

view full answer...

Recommended Locking Hitch Pin For Curt RockerBall Towing Kit # C63KR

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching