Does Zerk Fitting On EZ Lube Spindle Need To Be Removed When Using Bearing Buddy?
Question:
My carry-on cargo trailer already has a zirc fitting that I grease to get grease to the bearing. Do I need to remove that Zirk fitting prior to installing the bearing buddy?
asked by: John L
0
Expert Reply:
Since your Carry-On Trailer has EZ Lube spindles with a zerk fitting you will need to go ahead and remove the zerk fitting to allow the Bearing Buddy Bearing Protector # BB2717 to send grease to the bearings and spindle.
I included a video of the # BB2717 for you to take a look at.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 2717 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 2.717 Inch
- Bearing Buddy
more information >
Continue Researching
- Article: Overview of Lubricating Grease
- Shop: Malone MicroSport to LowBed Trailer Conversion Support Tubes - Qty 2
- Shop: Dexter Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2
- Q&A: Replacement Bearings and Hub for Malone MicroSport Trailer
- Shop: Trailer Idler Hub Assembly for 2K Axles - 10" to 12" Wheels - 5 on 4-1/2 - Pre-Greased
- Shop: Malone LowBed MicroSport Trailer - 78" Crossbars - 800 lbs
- Shop: Bunk Kit for Malone Trailers - 1 Kayak
- Video: Review of Malone MicroSport To LowBed Trailer Conversion Support Tubes - MAL33TR
- Video: Review of Dexter Trailer Hubs and Drums - Hub - 34822545BX
- Video: Bearing Buddy Trailer Bearings Races Seals Caps - Caps - BB2717 Review
- Shop: Kenda 5.70-8 Bias Trailer Tire with 8" Galvanized Wheel - 5 on 4-1/2 - Load Range B
- Shop: Malone MicroSport Trailer - 78" Crossbars - 800 lbs
- Q&A: Replacement Bearings for Malone MicroSport Trailer
- Q&A: Trailer Hub Assembly Must be Put Together and Packed with Grease
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: Replacement Hubs for Malone MicroSport Kayak Trailer
- Q&A: Could/Should Zerk Fitting of EZ Lube Spindle Be Removed to Install Bearing Buddies
- Q&A: Tips for Removing Zerk Fitting of EZ Lube Spindle to Install Bearing Buddy