Can Brake Controller of 2018 GMC Sierra 3500 be Bypassed with Aftermarket One
Question:
I would like to know if I can add a after market brake controller to my 2018 GMC 3500HD that already has the factory brake controller. Is this possible? If so, just plug and play? Or, computer the factory controller?
asked by: Jeff L
Expert Reply:
In order to bypass your factory installed controller in your 2018 GMC Sierra 3500 and install an aftermarket brake controller like the Prodigy P2 Trailer Brake Controller, # 90885, with Plug-In Wiring Adapter, # 3016, you will have to make a couple of cuts and connections.
You will then take a length of wire, # 10-1-1, and connect it to the blue wire you removed from the connector.
Route the blue wire through the firewall, under the truck, and to the trailer connector. Avoid hot or moving parts like suspension and exhaust.
At the trailer connector, remove the wire in the 7 oclock position (looking at the back of the connector where the wires attach). Tape it up and stow it out of the way. Then attach the wire you ran to the 7 oclock position. This will bypass the factory controller without causing any dash lights/error messages to appear.
The 10-1-1 wire is sold in lengths of 1 foot. So if you needed 20 feet you would put 20 in the quantity box.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)