Will Hub & Drum With 6 on 5-1/2 Bolt Pattern Allow Switching to 6 Lug Wheel  

Sounds like you are asking about the wheel bolt pattern of the Dexter trailer hub part #84545BX. This has a bolt pattern of 5 on 4-1/2 inch which is the most common 5 bolt pattern for trailer wheels. I attached a picture and link for more info on…

It is not possible to run 17 inch wheels with the Timbren Axle-Less Trailer Suspension System - 4" Lift Spindle w/Flange - Off-Road Tires - 2.2K #ASR1THDS03. The largest wheels you can run on a hub that fits the spindles on these Timbrens…

To change your hub bolt pattern will require you to change hubs to one that has the bolt pattern you need. You will need to know what spindle you have on your trailer. In order to do that you can either get the inner and outer bearing numbers from…

To charge the marine battery in your trailer you need to run some wiring from the pin in the 11 o'clock position on your trailer 7-Way to your marine battery (see attached photo). This should be the same wire that your breakaway kit is connected…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…