Where Are Fascia Removal Tabs Located on 2012 BMW 128i
Question:
where are the tabs that hold on the fascia?
asked by: Glenn B
Expert Reply:
I've linked the instructions for the Curt # C11184, but it shows the tab for the fascia; the tab should be located at the spot where the fascia meets the bumper. You will want to push in on the fascia to get it to disengage from the bumper. If you check out the linked instructions it shows 2 pictures- one of the bumper fascia tab and one where the fascia has been removed and the side plate is installed. The small holes there show where the tabs are going to catch on the bumper plate, so you'll just want to push on the fascia where those two pieces meet and it will pop the tabs out.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Q&A: Does Curt Trailer Hitch C11184 Fit a 2013 BMW 128i Convertible
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Q&A: Does the Curt Trailer Hitch # C11184 Fit a 2012 BMW 128i Convertible
- Q&A: How to Install the Curt Trailer Hitch Receiver on a 2013 BMW 128i
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Trailer Hitch And Wiring For 2014 BMW X1 AWD Turbo
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How Long is the Curt Class II Ball Mount D-55003/45503
- Q&A: 4 Pole Circuit Tester Power Source
- Q&A: What Size Hitch Pin do I Need for my Curt 1 1/4" Hitch
- Article: Trailer Hitch Installation Tips