Will the Thule Hull A Port Fit a Nissan Pathfinder Factory Rack

Question

Question:

Will the Thule Hull A Port XT fit on a 2013 Nissan Pathfinder with factory installed roof rail cross bars, for 2 kayaks? Thank you

asked by: Amy C

0

Expert Reply:

Yes, the Thule Hull-A-Port Kayak Carrier part # TH834 will fit a 2013 Nissan Pathfinder with factory rack.

expert reply by: Conner L

0

Answer 1

There is not a general restriction from Thule that says two Hullavator Kayak Carriers #TH898 can't be used on a Thule roof rack. As long as the crossbars on your Ford Escape have the required length for two sets and a sufficient weight capacity…

view full answer...

Answer 2

Yes, the 58" long crossbars for the Malone AirFlow2 Roof Rack #MPG216 will provide you with enough length to properly install the Thule Hullavator Pro #TH898 on your 2017 Nissan Pathfinder. Thule confirms that the Hullavator Pro will work with…

view full answer...

Answer 3

The Thule Hullavator #TH898 requires a set of aftermarket crossbars that extend past the feet of the rack 4 to 8 inches. I tried to find a roof rack for your 2017 Inifiniti Q60 that would work or find info on the factory rack but could not find…

view full answer...

Answer 4

You will need to install aftermarket crossbars because the Thule Hullavator #TH898 requires crossbars that hang over the edge of the roof at least 4" on each side, which your factory roof rack does not do. For this, I would go with Thule WingBar…

view full answer...

Answer 5

For your application I recommend using the Thule WingBar Evo setup because it looks great and is easy to use and install. The parts you'll need for your 2017 Nissan Pathfinder include the following: 53" WingBar Evo Crossbars - #TH711420 Evo…

view full answer...

Answer 6

For your 2018 Honda HR-V to be compatible with the Thule Hullavator Pro Kayak Carrier and Lift Assist with Tie-Downs #TH898, you have to use slightly longer crossbars. The Hullavator requires 4-8 inches overhang to give clearance. In order to give…

view full answer...

Answer 7

The Yakima ShowDown Kayak or SUP Carrier and Lift Assist part #Y04081 requires about 42" of crossbar space. Therefore, you'd wouldn't be able to realistically fit two side by side. I'd suggest using the etrailer J-Style Kayak Carrier…

view full answer...

Answer 8

To use the Yakima ShowDown #Y04081 you would need a roof rack where the crossbars extend past the legs at least 3-1/2". From what I can tell, the Mopar roof rack for your 2018 Jeep Grand Cherokee has crossbars that end where the legs fit. I do…

view full answer...

Answer 9

The Thule Hullavator part #TH898 takes up approximately 28.5 inches of cross bar space so you would need at least 57 inch bars, therefore the 65 inch bar you mentioned will work. Keep in mind that the Hullavator requires 4-8 inches of cross bar…

view full answer...

Answer 10

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Will the Thule Hull A Port Fit a Nissan Pathfinder Factory Rack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching